OverviewLink aggregation between Cisco switch and Huawei switch can cause connection problem if we don not configure int correctly. One of the common problem is we will get packet loss frequently for point to point between switches.In this article will show show how to configure LACP properly between Cisco switches model 3850X and model 2960 with Huawei switch model CE6800. PrerequisitesIn this article, it is presumed that:a. You have already connected the cables properly to the each ports.b. You have a direct console access to switch. # int g0/1channel-group 1 mode active# int g0/2channel-group 1 mode active# int po1switchportswitchport mode trunkswitchport trunk encapsulation dot1qswitchport trunk allowed vlan 15,25# sh eth 1 sumOn Cisco Switch 2960 # int g0/1channel-group 1 mode active# int g0/2channel-group 1 mode active# int po1switchport mode trunkswitchport trunk allowed vlan 15,25# sh eth 1 sum 4. ConclusionNow you should be able to configure LACP between Cisco switch and Huawei switch.
Cisco Nexus 5000
If you have any questions or suggestions you can always leave your comments below. I will try all of my best to review and reply them.